Nordson iControl - Installation; Installing Gateway into Icontrol Auxiliary Console

iControlr PROFIBUSr, PROFINETr, DeviceNett, and EtherNet/IPt Generation 4 Slot 9 Gateway
5
Part 1605930−02
E 2020 Nordson Corporation
Installation
WARNING: Allow only qualified personnel to perform the following tasks.
Follow the safety instructions in this document and all other related
documentation.
WARNING: Use dust-tight conduit connectors or strain reliefs to route
cables into all electrical enclosures. Installation must be done according to
code and care must be taken to maintain the dust-tight integrity of the
enclosures.
Installing Gateway into iControl Auxiliary Console
See Figure 2. The Gateway may be inserted into Slot 9 of the iControl card
cage.
NOTE: In some applications, the iControl card cage is mounted in a
custom-built electrical enclosure.
Card Cage
iControl Sub Panel
Slots 1 −8 reserved for
Dual Gun Driver PCAs
Slot 9 for Gateway
iControl Auxiliary Console
Figure 2 Installing Gateway into iControl Auxiliary Console