100 %
50 %
Service
interval
500 h
Reset
Now you can clean
the screen
Time left: 59 s
Operation
4-54
P/N 7105144G
2008 Nordson Corporation
VersaBlue_NW
Melter (contd.)
Screen 2: Units, Ready Delay Time, Password, Service
Interval, Field Bus
(contd.)
Backlight / Contrast
Backlight: 50 % or 100 % selectable
Contrast: adjustable in increments of 2 %
Fig. 4-64
Service Interval Setup
When the Service interval time defined by the customer has expired, the
service symbol (open-jawed wrench) lights up on the starting screen. The
symbol can be used e.g. to signal that the filter needs to be changed.
Reset
The time for the service interval is reset, and the service symbol
is switched off.
Fig. 4-65 V16
500 h (total hours with heaters on)
Screen cleaning
The screen can be cleaned until the time shown has expired, without
accidentally triggering any features. An indication is issued when the time
has expired, and 10 s later the previous screen appears again.
Fig. 4-66 V20
To Next Page
Loading...
