Nortel CallPilot - Working with DIMMs and the CPU; Replacing or Adding Baseboard DIMMs

CallPilot Configuration Wizard 143
q. After the CallPilot resource group is online on CP1, restart CP2.
5
On CP1, do the following:
a. Launch the AutoStart Console.
b. Wait until node CP2 and both drvE and drvF are online/green in
the AutoStart Console.
c. Enable monitoring for the CallPilot resource group. For more
information, see "Enabling automatic failovers (start monitoring)"
(page 214).
—End—
Change the Media Allocation
Use the following procedure to modify the MPB96 board or DSP resource
settings.
Changing the Media Allocation
Step Action
1
On CP1 (the active High Availability server) do the following:
a. Ensure the dongle is plugged into CP1. If the dongle is not on
CP1, move it to CP1 and wait for 3 minutes.
For more information about the dongle, see 1005r Server
Hardware Installation (NN44200-308).
b. Launch the AutoStart Console.
c. Stop monitor ing on the CallPilot resource group. For more
information, see "Disabling automatic failovers (stop monitoring)"
(page 213).
d. Log on to CallPilot Manager on CP1 and start the Configuration
Wizard.
e. Select the CallPilot Individual Feature Configuration
(Express Mode) option and then click Next.
Result: The Configuration Wizard: Express Configuration List
screen appears.
f. Select the Media Allocation check box.
Result: The Media Allocation window appears.
g. Select the MPB96 board to be modified.
h. Change the DSP resources as required.
Nortel CallPilot
High Availability: Installation and Configuration
NN44200-311 01.06 Standard
5.0 15 May 2007
Copyright © 2007, Nortel Networks
.