To Next PageTo Next Page
Need help?Do you have a question about the Nortel 1000E and is the answer not in the manual?
Provides information necessary to install and configure a Nortel Networks Communication Server 1000E system.
Details the systems to which this document applies, specifically the Communication Server 1000E.
Lists information sources that relate to this document, including NTPs and other documentation.
Provides guidance on exercising care when lifting system components and getting assistance if necessary.
Lists precautions for handling circuit cards, including static electricity awareness and proper storage.
Outlines safety instructions specific to installing telephone equipment.
Lists the tasks involved with the installation of a CS 1000E system, referencing page numbers for each task.
Describes the CS 1000E Call Server, its processor, enhancements, and physical appearance.
Details the Signaling Server, its software components, and its role in providing signaling interfaces.
Describes the Media Gateway, its function, product code, and profile.
Describes the Media Gateway Expander, its profile, and slot assignments.
Provides guidelines for placing components in a rack, considering LAN cabling, vertical mounting, and power.
Details the procedure and items required to rack-mount a CS 1000E Call Server.
Explains how to mount Media Gateways and Expanders in a 19-inch rack, including required items.
Describes how to install Signaling Server hardware into a 19-inch rack.
Details the installation of NTBK80 and NTDU6201 Ground Bars for system grounding.
Explains how CS 1000E Call Servers are properly grounded.
Describes how to connect Call Server 0 and Call Server 1 for redundant architecture and Campus Redundancy.
Explains how CS 1000E Core Call Servers connect to an MG 1000E for direct control.
Details the procedure for connecting a Signaling Server to the ELAN subnet.
Provides steps for installing CS 1000 Release 4.5 software for the CP PIV.
Guides through verifying Call Server functionality, including redundancy and network calls.
Details how to enable the Login Name option for CS 1000E Call Server access.
Explains how to configure system login usernames and passwords for increased security.
Provides instructions on how to log in to Element Manager for system configuration.
Describes how to import IP telephony configuration files from the Signaling Server.
Details the software installation process for the MG 1000E Small System Controller using the delivery card.
Lists required MRV serial cables and connectors for Terminal Server installation.
Explains how to run telnet from a PC to access the Terminal Server virtual management port.
Describes how to check the status of ELAN network interfaces by observing LEDs and using commands.
Guides on checking the status of MG 1000T Core to Expansion 100BaseT links using LEDs.
Explains how to install a Voice Gateway Media Card into a Media Gateway or Expander slot.
Outlines methods for verifying a card's status, including checking boot messages and LED displays.
Provides instructions for installing a BIX cross-connect terminal.
Details the installation of a Krone Test Jack Frame for UK cross-connect terminals.
Guides on logging into Element Manager via a web browser for IP telephony node configuration.
Describes importing IP telephony node files from the leader Signaling Server using Element Manager.
Details the installation of IP Phone hardware, including footstand, switch, cables, and power.
Explains how to manually configure IP Phone boot parameters like IP address, subnet mask, and gateway.
Provides instructions for installing and connecting a QUA6 PFTU to the system.
Details how to connect analog telephones to a PFTU using cross-connect wires.
Describes configuring basic system features using overlays and the data-entry-sequence for new systems.
General
