Page 264 of 488 Connecting a Terminal Server
553-3041-210 Standard 4.00 September 2007
7 Define a user name for the port. Enter the command:
DEFINE PORT 2 USERNAME “pty7”
Note: When typing the letters “pty”, they must be lower case letters. The
number must equal the pty number configured on the system.
8 Log out of the port. Enter the command:
LOGOUT PORT 2
End of Procedure
Accessing an MRV Console Port through the
on-board modem
The MRV IR-8020M Terminal Server is equipped with a V.90/K56flex 56
Kbps on-board modem. The modem port is 23. Follow Procedure 68 to access
an MRV Console Port through the on-board modem.
Procedure 68
Accessing an MRV Console Port through the on-board modem
1 Connect an analog telephone line to the MRV telephone line port.
2 Set up the remote PC connection.
3 Dial in to the MRV onboard modem from the PC.
4 From the PC, run HyperTerminal. Enter the command:
ATD [phone number]
Screen response:
CONNECT 9600/ARQ/V34/LAPM/V42BIS
Login
5 Log in to the In-Reach Element Manager using the default password, (see
steps 4,5,6,and 7 in Procedure 62 on page 256).
End of Procedure
Once logged in to the on-board modem, it is possible to telnet to ports 1-20.
It is also possible to rlogin to different IPs.
To Next Page
Loading...
