Nortel 1000E - Page 263

Connecting a Terminal Server Page 263 of 488
Communication Server 1000E Installation and Configuration
9 Check port configuration. Enter the command:
LIST PORT xx
LIST PORT xx ALTERNATE CHARA
Where:
xx = port number
End of Procedure
Configuring a transparent rlogin port with sample data
Sample data has been incorporated into Procedure 67. This configuration
shows that a device connected to MRV Port 2 will rlogin 47.11.166.76
through pty 10.
Procedure 67
Configuring a transparent rlogin port
1 Enable keepalive timer 1 for the port. Enter the command:
DEFINE PORT 2 IP TCP KEEPALIVE TIMER 1
2 Enable a dedicated service using rlogin. Enter the command:
DEFINE PORT 2 RLOGIN DEDICATED SERVICE 47.11.166.76
3 Enable the port to be accessible only by local command and from a serial
connection only. Enter the command:
DEFINE PORT 2 ACCESS LOCAL
4 Enable the In-Reach Element Manager to complete a ZMODEM transfer
using the rlogin feature. Enter the command:
DEFINE PORT 2 RLOGIN TRANSPARENT MODE ENABLED
5 Enable autoconnect for the port. Enter the command:
DEFINE PORT 2 AUTOCONNECT ENABLED
6 Enable autodedicate for the port. Enter the command:
DEFINE PORT 2 AUTODEDICATED ENABLED