Nortel 1000E - Connecting MG 1000 T System Components; Contents; Introduction

Page 153 of 488
Communication Server 1000E Installation and Configuration
168
Connecting MG 1000T system
components
Contents
This section contains information on the following topics:
Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 153
Connecting an MG 1000T Core to a Survivable MG 1000T Expansion 156
Connecting an MG 1000T Core to the ELAN subnet . . . . . . . . . . . . . . 161
Connecting a Signaling Server to the ELAN subnet. . . . . . . . . . . . . . . 162
Connecting a Signaling Server to the TLAN subnet. . . . . . . . . . . . . . . 163
Inserting a Shielded 50-pin to Serial/ELAN/TLAN adapter onto a
Media Card . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 163
Connecting a Media Card to the ELAN . . . . . . . . . . . . . . . . . . . . . . . . 165
Connecting a Media Card to the TLAN subnet. . . . . . . . . . . . . . . . . . . 166
Connecting a Media Gateway to a Media Gateway Expansion . . . . . . 166
Introduction
Several system connections are required to make the MG 1000T operational.
The MG 1000T must be connected to the CS 1000E through the TLAN
subnet. The MG 1000T Core is directly connected with a CAT5 cross-over
cable to each of the MG 1000T Expansions. The Media Gateway is directly
connected to the Media Gateway Expander. The system’s components, such