Page 4 of 8
Change the Name of a Set
1. Press FEATURE ** 266344
2. Password: 23646, press OK
3. See Terminals and Sets: press SHOW (top right button)
4. Enter the extension number
5. Press SHOW
6. Press NEXT until you see the current name (NEXT=second key down on right hand
side)
7. Press CHANGE (see on display)
8. Spell out the new name, press # after each letter
9. Press NEXT
10. Press RLS to exit programming
Program/Make Changes to Call Forward No Answer or Busy
1. Press FEATURE ** 266344
2. Password: enter 23646 Press OK
3. See TERMINALS AND SETS: press SHOW
4. Enter the extension number
5. Press SHOW, then press NEXT, see CAPABILITIES, press SHOW
6. See Fwd no answer: press SHOW
7. See the extension number where calls are being forwarded (usually the voicemail ext. If
unknown press Feature 985 and display will show vmail ext)
8. Press CHG to enter a different extension OR
9. Press NEXT to see the number of rings and press CHANGE if you want to change the
number of rings
10. Press HEADING (top left button) then NEXT to make changes to call forward BUSY
11. Press SHOW then CHG and enter in vmail ext.
12. RLS to exit programming
Program System Speed Dials
1. Enter FEATURE ** 266344
2. Password: enter 23646, press OK
3. Press NEXT until you see SYS SPEED DIAL
4. Press SHOW
5. Enter a speed dial code : 001-255, press SHOW
6. Press CHNG on display and enter the phone number, then press OK
7. Press NEXT, then CHG until you see POOL
8. Enter 9
9. Press NEXT then press CHANGE to enter a NAME for the speed dial OR go to step 9 if
no name wanted; if entering a name, press NEXT then CHANGE, spell out name (
press # after each letter), then press NEXT
10. Then HEADING to enter another speed dial
To Next Page
Loading...
Need help?
General
