Novatech Bitronics M660 - Indicators - Ethernet (ACT) & Fiber Leds; Firmware Upgrades and Saving and Loading Configuration Files - Ethernet Service Port

34
ML0042 October 15, 2019 Copyright 2019 Bitronics, LLC
<ms> := period between polls (100ms)
<mac-spec> := <6ByteMac> | <[3-5]ByteMac> | <macRangeName>
<6ByteMac> := xx:xx:xx:xx:xx:xx - <cnt> can specify a range to scan
<5ByteMac> := xx:xx:xx:xx:xx - default <cnt> is 256
...
<3ByteMac> := xx:xx:xx - default <cnt> is 16,777,216
<macRangeName> := "60series"
60Series MAC base (00:d0:4F:03), default <cnt> is 65,536
-v := request verbose information
CTRL-C stops a scan.
The inarp utility requires the WinPcap and Packet libraries which are bundled in the
WinPcap "Installer for Windows." This can be downloaded from www.winpcap.org.
Installation requires Administrator privileges.
Examples:
to poll the 1st IPv4 interface,
inarp -v 60series
CTRL-C stops the scan
to poll the IPv4 interface associated with 192.168.1.1, use
inarp -v -i 192.168.1.1 60series
or to poll a specific mac, use
inarp -v -i 192.168.1.1 00:D0:4F:03:00:15
The inarp utility is Copyright (c) 2011 by Bitronics, LLC. All rights reserved.
Portions of inarp are
Copyright (c) 1999 - 2005 NetGroup, Politecnico di Torino (Italy), and
Copyright (c) 2005 - 2010 CACE Technologies, Davis (California)
3.4.2 Indicators – Ethernet (ACT) & Fiber LEDs
There are 2 LEDs on the rear panel to indicate activity is occurring on the
communication ports. These LEDs are useful in determining that there is activity
occurring on the ports. The "ACT" LED will flash to indicate there is activity on the
Ethernet RJ45 port. It will also indicate that a link has been established. The “FIBER”
LED flashes to indicate there is activity occurring for the fiber port.
A troubleshooting guide is found in Appendix A2, which may be useful in establishing
Ethernet connections.
3.4.3 Firmware upgrades and saving and loading configuration files – Ethernet
service port
New versions of firmware may be released by Bitronics from time to time, either to add
new functionality or to correct errors in code that may have escaped detection prior to
commercial release. Consult the factory for detailed information pertaining to the