Radio Configuration and Activation Chapter 5
ProPak6 Installation and Operation User Manual Rev 4 91
5.3.3 Eject a SIM Card
Issue the CELLULARCONFIG POWER OFF command to power down the cellular radio before removing a
SIM card.
To remove the SIM card, push it slightly in. It should then partially eject from the SIM card holder. The
modem does not work if the SIM is in the partially ejected “ready for removal” position. Replace the SIM
Card holder cover and ensure the cover is properly aligned and secured.
Issue the CELLULARCONFIG POWER ON command to turn the cellular radio on.
5.4 Airplane Mode
Enabling Airplane Mode turns off any Wi-Fi, Bluetooth or cellular radios in the ProPak6. Airplane Mode is
disabled by default (radios on). If Airplane mode is enabled and then disabled, all radios automatically
return to their last state (on or off) however, any connections made before airplane mode was enabled
are not restored. Refer to the AIRPLANEMODE command and log in the OEM6 Firmware Reference
Manual (OM-20000129) for command details.
To turn all three radios off, issue the following commands:
AIRPLANEMODE ENABLE
AIRPLANEMODE DISABLE
LOG AIRPLANEMODE (to view radio status)
To Next Page
