EN-9
7.4 DAB + Radio
DAB mode receives DAB/DAB+ digital radio and displays information about the station, stream, and track
playing.
Scanning for stations
The first time you select DAB radio mode, or if the station list is empty, the radio automatically performs a
full scan to see what stations are available. You may also need to start a scan manually to update the list of
stations.
To start a scan manually, choose Full scan. To scan only stations with good signal strength, select Local
scan. Once the scan is complete, the radio shows a list of available stations.
To remove stations that are listed but not unavailable, choose Prune invalid. Turn the navigate reel to view
a list of stations and press to select. Once selected, the station plays and the screen show information
about station, track or show as broadcast.
Settings
● Dynamic range compression (DRC): If you are listening to music with a high dynamic range in a noisy
environment, you may wish to compress the audio dynamic range. This makes quiet sounds louder,
and loud sounds quieter. You can change DRC as off, low, or high.
7.5 FM Radio
FM radio mode receives analogue radio from the FM band and displays RDS (Radio Data System)
information about the station and where broadcast.
To find a station, press OK. The frequency display starts to run up as the device scans the FM band.
Alternatively, you can scan up or down by holding and pressing / on the remote control or tuning
manually with quick presses. For up and down adjusts, you can press / on the remote control or
press the TUNE button once and then turn the reel.
Settings
● Scan settings: By default, FM scans stop at any available station. This may result in a poor signal-to-
noise ratio (hiss) from weak stations. To change the scan settings to stop only at stations with good
signal strength, select “Yes” after choosing “Strong station only?”
● Audio settings: All stereo stations are reproduced in stereo. For weak stations, this may result in a
poor signal-to-noise ratio (hiss). To play weak stations in mono, select FM weak reception: “Listen in
mono only”, and then “YES”.
7.6 Bluetooth
In Bluetooth mode, you can turn on the Bluetooth of your Bluetooth device. Go to the menu and turn
Bluetooth discoverable. From your Bluetooth device, search for the A571 CD to pair. When it is waiting for
pairing, there is a blinking Bluetooth icon at the bottom. If the pairing is successful, the Bluetooth icon
becomes steady. Control the music playback from your Bluetooth device.
Press / on the remote control to go back to the forward track or go to the next track. Press to
play or pause the track.
To Next Page
Loading...