NPK
- 15 -
LUBRICATION
GREASING PROCEDURE
Manual greasing for hammers without AUTOLUBE system
IMPORTANT:
1. The hammer must be in a vertical position with downforce applied to push the tool all
the way in. This prevents grease from entering piston impact area.
2. Turn the machine off.
3. Grease the hammer until grease begins to come out around the tool and lower
bushing.
APPLY DOWNFORCE TO PUSH TOOL UP INTO HAMMER
NOTE: USE A GOOD QUALITY EP #2 LITHIUM BASED GREASE WITH WEAR
INHIBITING ADDITIVES, SEE PAGES 16, 17, AND 18.
To Next Page
Loading...
