NSK NLX Plus - Connecting and Disconnecting Handpiece; Pre-Treatment Checks

9
English
Preparation for Use
Follow the Instruction manual for VIVA ace Basic Set.
(
Reference
:
5-10 Check before treatment
)
<Disconnecting>
Holding the front part of the Motor and the end
part of the Handpiece, gently pull straight apart.
4-4 Check before treatment
4-3 Connecting and Disconnecting the Handpiece (optional)
CAUTION
• Use the following handpiece.
-ISO 3964
(
EN 23964
)
compliant handpiece
-93/42/EEC compliant handpiece
• Connect/disconnect the Handpiece after the Motor has completely stopped.
• Adjust the speed within its allowable speed of the Handpiece (optional).
• Do not leave the lubricated Handpiece attached to the Motor. The oil may enter the Motor and cause a
malfunction.
• Keep the lubricated Handpiece in a different place in a standing condition and attach it to the Motor before
using it.
• Be careful not to get water into the Motor because it could cause a malfunction.
Positioning pin
Handpiece
(optional)
Motor
Insert the Handpiece straight into the Motor.
When connecting an optic handpiece, turn
the Handpiece either to the right or left
until hearing a clicking sound securing the
position.
1
Confirm that the Handpiece is connected
firmly.
2