Why is my NSK Engine overheating during use?
If your NSK Engine is abnormally heating during rotation, it could be due to continuous use over a long period. Stop operating the Attachment/Handpiece and Motor immediately. Wait until the Attachment/Handpiece and Motor cool down before continuing to operate.
What to do if my NSK Engine doesn't rotate when pressing the hand switch?
If your NSK Engine is not rotating when the Hand Switch is depressed, it could be due to a couple of reasons. First, check if the Twist Collet on the Attachment/Handpiece is open; if so, fasten it after inserting the Bur by turning it in the correct direction. Also, verify if the Safety Lock is activated ("ON"). If it is, release the Safety Lock.
How to fix vibration and noise issues with my NSK Engine?
If you're experiencing vibration, noise, or bur run-out with your NSK Engine, the suggested solution is to contact your dealer for assistance.
Why is my NSK Engine not rotating after I attach a bur?
If your NSK Engine isn't rotating after attaching a bur or other instruments, it might be because the Twist Collet on the Attachment/Handpiece is open. Make sure to fasten the Twist Collet after inserting the bur by turning it in the indicated direction.
Details the parts of the P200 series Motors, including switches, locks, and cord plugs.
Illustrates and names the parts of the P200-WPD Wire Pin Driver, such as triggers and cord plugs.
Guides on how to properly connect the Motor's cord plug to the Control Unit's connectors.
Describes the correct methods for attaching and detaching various handpieces and attachments to the motor.
Step-by-step instructions for operating the motor using the hand control unit.
Instructions for operating the Primado2 Wire Pin Driver, including trigger functions and modes.
Details on how to use the foot control pedal and buttons to operate the Primado2 system.
Covers initial preparation steps and basic cleaning methods for the motor and its accessories.
Explains the recommended procedures for washing and disinfecting the motor using a Thermo Disinfector.
Details the autoclaving conditions for sterilization and guidelines for storing the sterilized motor.
To Next Page
General
