8
CAUTION
NOTICE
Ř Always insert the bur all the way into the chuck.
Ř Remove the bur only after the handpiece has completely stopped rotating.
Ř Always keep the bur shank clean.
Ř Entry of debris into the chuck, via the bur shank, could cause bur rotation slip and also prevent the bur from being securely located in the
chuck.
Ř Do not exceed the bur speed recommended by the bur manufacturer.
Ř Do not exceed maximum bur length recommended by the handpiece manufacturer.
Ř Do not apply excess pressure to the bur as it may break or bend or become difficult to remove.
Ř DO NOT use burs with problems listed below as the bur may break, seize up or disengage from the chuck.
- Bent, deformed, anisomerous (worn), rusted, broken, deficient bur.
- Bur which is cracked on the edge or axis.
- Non-ISO standard, or tampered bur.
Ř Grip the handpiece while placing your thumb tip on the Push button which makes it easier to depress the button.
To Next Page
Loading...
Need help?
General
