Chapter 3. Preparing for Operation
Fig. 3-12
1 – approach knob; 2 – seats of the measuring head
2. Place the screw legs of the measuring head down to the seats 2 of the exchangeable
mount (see Fig. 3-13). Observe that the probe tip does not contact with the sample
surface or with parts of the microscope.
Fig. 3-13. Measuring head installed on the base unit
ATTENTION! Length of the measuring head legs is adjusted during
the installation procedure. Do not re-adjust it as this will result in
inclination of the objective and thus in misalignment of the optical
detection system.
29
To Next Page
Loading...