NTI ENVIROMUX Series Installation & Operation Instructions

2
Mounting the E-LDA-LC2
 Secure or locate a sufficient length of DIN rail on the desired mounting surface for installation
 Remove the E-LDA-LC2 from its packaging and snap onto the DIN rail with the release tab towards the top. Shown
in Figure 1.
Figure 1: Mount to DIN Rail
Connections for Power
To power the E-LDA-LC2, connect the 12VDC power supply (included) to the “VCC” and “GND” terminal.
Figure 2: Power connections
Connections for Alarm Relay
The E-LDA-LC2's output relay contact can be used to control a siren or beacon for local alert or for controlling valves, other
devices, or automatic input systems. When wired properly, the relay can also be used to cause the E-xD to send an alert
message via email, SMS, SNMP or SYSLOG. The relay only changes state if there is a water leak. The output relay can
be normally-open or normally-closed, giving a level of customization. See the table below for configuring alerts.
Figure 3: Relay connections

NTI ENVIROMUX Series Specifications

General

Product Type	Environmental Monitoring System
Temperature Range	-40°C to 85°C
Power Supply	12V DC or 24V AC
Network Interface	Ethernet 10/100 Mbps
Alarm Notifications	Email, SNMP
Sensor Types Supported	Temperature, Humidity, Water, Airflow
Power	12V DC or 24V AC
Operating Temperature	-40°C to 85°C
Mounting	Wall or Rack Mount
Communication Interfaces	Ethernet
Data Logging	Yes
Compliance	CE, RoHS