en-938821/2 5 - 73
CNC Operation
5
Note concerning edit mode
Calling the edit mode when a programme is being executed interrupts execution at the end of the block (See 5.4.3.2).
If there are any duplicated programmes (See above), they are not accessible and any attempt to call them results in
the following message being displayed:
ACCESS TO PROGRAM DENIED: AWAIT RESET
For these programmes to be called in edit mode, they must first have been enabled by the end of execution of the active
programme (M02).
Incidents
There is insufficient memory to store a duplicated program
Display of the message:
PROGRAM MEMORY FULL
Loading is in progress
Display of the message:
REFUSAL: Program zone access conflict
Acknowledge the message. ☞
Wait for the end of the loading procedure and then restart the procedure.
The "BACKGROUND EDIT" function cannot be accessed
The interactive programming function cannot be accessed in background mode except in the authorised modes (See
requirements).
Display of the message:
REFUSAL: Disallowed in this mode
Exit by selecting a display page.
Exit from the procedure
Exit the background edit function by selecting a display page.
All modifications are stored and will be enabled when the active programme has been executed.
To Next Page
Loading...
