en-938821/2 5 - 75
CNC Operation
5
Display of the line selected.
Start loading. ☞
Display of the message:
Request access to serial link
Exit with message: "<<--"
Start the data transmission procedure over the link.
Display of the message:
Loading in progress
Display of the message:
Loading completed
Exit with message: "<<--"
The programmed is stored.
Acknowledge the message displayed. ☞
Loading of several consecutive programmes not separated by Xoff characters
If several programmes not separated by Xoff characters (ASCII character code 19) are included in the loaded file, the
programmes are loaded one after the other.
Loading of several consecutive programmes separated by Xoff characters
If several programmes are included in the loaded file, reading stops when an Xoff character is encountered.
Start the procedure to load the next programme. ☞
Each programme is loaded in the same way.
Incidents
The loaded programme has the same number as a programe already in memory
Display of the message:
Existing program
Exit with message: "<<--"
Acknowledge the message. ☞
Display of the message:
PROG. EXISTS - OK TO OVERWRITE ? (Y,N) :❚
Enter the letter corresponding to the desired action (Y for yes, N for no). ☞
A positive answer causes the old programme to be overwritten and the new programme to be stored.
A negative answer cancels the data loaded.
To Next Page
Loading...
