Nuna Aace - Seat Assembly and Latch System; Side Impact Protection

EN EN
3837
4
5
This booster must be installed in
vehicle seats with 3-point seat belts
(lap and shoulder belts). (4)
This booster can be installed with lap
and shoulder belts in a vehicle seat
that includes Latchs. The Latchs
must be at standard spacing 11”
only. (5)
Please refer to the vehicle owner’s
manual for designated Latch
locations in the vehicle.
The child must be restrained using the Vehicle Shoulder Belt
and Lap Belt.
DO NOT use the Latchs to restrain the child. The Latchs are
only to be used for securing the booster seat in the vehicle and
to function the recline feature in the High Back booster mode.
The Latchs can only be used in the No Back booster mode for
securing the booster seat in the vehicle.
The recline feature is NOT available in the No Back booster
mode.
6
7
8
9
1
2
Seat Assembly
1 With the seat lying at, attach the
Seat Back to the booster Seat
Bottom by hooking the Seat Back
hooks over the Seat Bottom as
shown. (6)
2 Now rotate the Seat Back up until it
clicks into position and the seat is
fully upright as shown. (7)
Side Impact
Protection
(SIP) Pods
1 To open the SIP Pods pull out on
the side tab (8).
2 To close push button (9)-1 and
push in (9)-2.
SIP Pods should be deployed
whenever the booster is installed in a
vehicle.