Nuna Aace - No Back Booster Mode; Securing Child in No Back Mode

EN EN
4847
Use as a No Back Belt
Positioning Booster
Your child must meet ALL of the following
requirements below:
Age: Approximately 4 – 12 years
Weight: 15 – 36kg
Height: 101 – 150cm
The No Back Booster can be installed with or without the Latch
Connectors.
If installing without the Latch Connectors, ensure the Latch
Connectors are stored in the seat bottom, refer to “Use of Latch
Connectors.” If the seat back is attached, remove the seat back by
reversing the steps shown in “Seat Assembly.”
Installing without Latch Connectors
Place the back of the booster against the back of the vehicle
seat back.
In the No Back Booster mode, the recline function cannot
be used.
Approximately 4 – 12 years
36kg
(150cm)
15kg
(101cm)
Installing with Latch Connectors
1 Remove the seat back by reversing steps shown in “Seat
Assembly.”
2 Connect the Latch Connectors to the vehicle’s Lower
Anchors. See “Use of Latch Connectors.”
3 While holding the Latch Release Lever, adjust the
booster until it is in contact with the vehicle’s seat back. Refer
to “Use of Latch Connectors.”
Securing a Child in the No
Back Booster Mode
1 With the booster correctly positioned in the vehicle, have
the child sit on the booster seat with their back against the
vehicle’s seat back. (27)
2 Route the Vehicle Belt through the RED lower belt path, located
under the armrest (27)-1 and toward the vehicle buckle then
secure the vehicle buckle and listen for a “click”. (27)-2
3 The booster can not be used if the vehicle safety belt buckle
(female buckle end) is too long to anchor the booster securely.
(27)-3
4 The Vehicle Shoulder Belt should lie at across the child’s chest
and the Vehicle Lap Belt should be snug across the child’s thighs.
The shoulder belt must lie across the child’s shoulder. (27)