Nuna Aace - Page 24

EN EN
4443
20
19
18
1
2
Use without Latchs
1 The back of the booster seat MUST t
tightly against the back of the vehicle
seat back when not using the Latchs.
(19)
2 Adjust or remove the vehicle headrest
as needed to remove interference.
If you remove your vehicle headrest,
be sure to stow it in a secure place;
check your vehicle owner’s manual.
3 Do not use with seat back beyond
position 2.
(20)
The front of the booster MUST NOT
hang over the front of the vehicle seat.
Your booster has two seat back
positions as shown, fully upright
(18)-1 and reclined (18)-2.
21
22
1
1
2
23
1
2
Use with Latchs and Recline Feature
The booster has a recline feature to best
t your vehicle and provide maximum
comfort to your child.
1 Place vehicle seat back in normal
upright position.
2 Connect booster to vehicle Latchs
(see Use of Latchs).Ensure bottom of
booster is in full contact with vehicle
seat. (21)-1
3 Adjust the seat bottom by holding the
Recline Lever and moving the seat
in or out to obtain desired recline as
shown in (22)-1.
4 Ensure the back of the booster is in
contact with vehicle seat as shown in
(22)-2.
5 Adjust or remove vehicle headrest as
needed to remove interference.
If you remove your vehicle headrest,
be sure to stow it in a secure place;
check your vehicle owner’s manual.
Warning! Never use booster when
reclined beyond the recline
position 2. (23)