Shoulder Belts
1 - Tighten harness to fit snugly on
child’s shoulders. It is snug if
you cannot pinch a fold in the
strap horizontally.
2 - Harness straps must be at or
just below shoulders.
3 - To adjust shoulder harness
height, first loosen harness by
pressing on adjustment button
while pulling on the harness
straps.
4 - Then turn child restraint over
and remove one harness loop
from metal splitter plate.
5 - Pull loose ends of harness
out through slots and place in
correct slot.
28 29PIPA rx instructions PIPA rx instructions
1
2
3
4
5
To Next Page
