Seat Pad
1 - Pull out the fastening pieces
under the edge of the seat.
The best way to work this area
(as some seat pads feel more
tight in this area than others) is
to pull the fabric towards the
front of the seat at one corner.
Once you have one corner out,
you can easily work the other
side out.
2 - Remove the harness from the
splitter plate.
3 - Remove the seat pad from the
stroller release buttons* as
shown.
*Feature used only with infant car seat
adapters. Infant car seat adapters for
strollers sold separately.
4 - Grasp the seat pad and pull
it out from under one edge of
the adjustment button. Work
around the adjustment button
to release the remainder of the
seat pad.
27PIPA rx instructions
1
2
3
4
26 PIPA rx instructions
To Next Page
