Nuna PIPA rx User Manual

38 PIPA rx instructions PIPA rx instructions 39
RELX
™
Base Stability Leg
Refer to vehicle owner’s manual
to determine if stability leg can
be used. See page 40 for base
installation instructions.
1 - Press release button on bottom
of base to release the stability
leg from storage.
2 - Let the stability leg hang over
the edge of the vehicle seat.
After correctly installing the
base on the vehicle seat, press
the stability leg adjustment
button and extend the stability
leg perpendicular to the floor.
3 - Extend stability leg far enough
that it contacts the floor, the
stability leg indicator turns
green, and the leg locks into
position. Make sure the stability
leg is firmly planted on the floor
of the vehicle and does not easily
slide around.
4 - Indicators should show green,
meaning the stability leg is
properly contacting the floor.
If the stability leg indicator
shows red, the stability leg is
not making firm contact with
the vehicle floor. Adjust as
needed. Stability leg should be
perpendicular to the floor.
(continued on the next page)
1
2
3
4

Nuna PIPA rx Specifications

General

Product Type	Infant Car Seat
Weight Capacity	4 to 32 lbs
Height Capacity	Up to 32 inches
Canopy	UPF 50+ canopy with flip out eyeshade
Harness	5-point harness
Base Compatibility	PIPA series base
Safety Features	Side impact protection
Safety Standards	FMVSS 213
Compatibility	Nuna strollers with adapters
Installation	Belt path or with base using True lock™ base installation
Weight of Car Seat	7.6 lbs (without base)