Nuna PIPA rx User Manual

53PIPA rx instructions52 PIPA rx instructions
Attaching Child Restraint
to RELX
™
Base
1
- After child is properly secured
in child restraint, lower child
restraint onto base and listen
for a click. Check that child
restraint is locked onto the base
by pulling up on the handle.
DO NOT allow child restraint
or handle to contact the vehicle
interior (side of car door or seat in
front) when installed on base.
Recline Adjustment
RELX features a recline you can use
on the go without uninstalling the
seat. Choose a position that matches
your child’s weight and height.
Recline positions 1 & 2:
4–20 lb, up to 32 inches
Recline positions 3 & 4:
21–32 lb, up to 32 inches
2 - While firmly pushing the recline
button all the way down, slide
the top of the base. Release the
button; if the button does not pop
back up, the recline is not locked.
Gently push or pull the top of the
base until it locks into position.
(continued on the next page)
1
2

Nuna PIPA rx Specifications

General

Product Type	Infant Car Seat
Weight Capacity	4 to 32 lbs
Height Capacity	Up to 32 inches
Canopy	UPF 50+ canopy with flip out eyeshade
Harness	5-point harness
Base Compatibility	PIPA series base
Safety Features	Side impact protection
Safety Standards	FMVSS 213
Compatibility	Nuna strollers with adapters
Installation	Belt path or with base using True lock™ base installation
Weight of Car Seat	7.6 lbs (without base)