Nuna PIPA rx User Manual

Locking Clip Use
If you determine that you need
to use a locking clip, tighten the
buckled belt by pushing down hard
on the infant child restraint and
pulling hard on the shoulder belt.
While pushing down on child
restraint, pinch the two straps
together behind the buckle tongue.
Unbuckle the vehicle belt without
allowing it to slip.
1 - Connect lap and shoulder belts
with locking clip.
2 - Reroute vehicle belt if
necessary. Check that lap belt
does not move by pulling and
pushing hard on infant restraint.
If belt loosens or lengthens,
repeat procedure.
The locking clip should be 1/2
inch (12.5 mm) from the vehicle
buckle.
2
PIPA rx instructions
1
2
61
1/2 in
(12.5 mm)
60 PIPA rx instructions

Nuna PIPA rx Specifications

General

Product Type	Infant Car Seat
Weight Capacity	4 to 32 lbs
Height Capacity	Up to 32 inches
Canopy	UPF 50+ canopy with flip out eyeshade
Harness	5-point harness
Base Compatibility	PIPA series base
Safety Features	Side impact protection
Safety Standards	FMVSS 213
Compatibility	Nuna strollers with adapters
Installation	Belt path or with base using True lock™ base installation
Weight of Car Seat	7.6 lbs (without base)