15
PRONTOBAR TOUCH
• Preparation of the installation site.
The purchaser must prepare the surface on which the machine will stand suit-
able to support the machine weight (see the installation chapter).
• Electrical requirements.
The mains power installation must comply with the safely regulations and
standards in force in the country of installation and must include an eicient
earth system. An omnipolar cut-o device must be installed on the power line
upstream of the machine.
PREPARATION BY THE PURCHASER
A General hazard
B Electrical shock hazard
C Burns hazard
D Hazard of damage to the machine
E Operation reserved for the qualified technician,
in compliance with current standards
SYMBOLS
RESIDUAL RISKS
Although the manufacturer has provided mechanical and electrical safety sys-
tems, dangerous areas persist during the use of the machine:
• Dispensing group.
• Steam wand / Easycream (optional).
• Hot water wand.
• Cup warmer.
• Plumbing requirements.
Prepare a suitable drain and a mains that supply water a maximum hardness
of 3/5 French degrees (60/85 ppm).
The power wires must be sized according to the max-
imum current required by the machine to ensure a
total voltage loss under full load of less than 2%.
A
C
E
B
D
To Next Page
Loading...
