Fig. 14
Fig. 15
Fig. 16
42
EN
4. INSTALLATION
AND PRELIMINARY
OPERATIONS
CAUTION
RISK OF POLLUTION
Do not dispose of packaging in the environment.
Before carrying out any installation and adjustment
operations you must read and fully understand the
SAFETY INSTRUCTIONS of this handbook. The com-
pany cannot be held responsible for damage to things
or injury to persons caused by failure to comply with
the safety instructions and installation and mainte-
nance instructions contained in this handbook.
CAUTION
RISK OF SHORT CIRCUITS
Before connecting the machine to the mains
power supply, please check that the supply vol-
tage corresponds to the machine voltage.
Place the machine on a flat, level surface to avoid
any possible malfunctioning.
Never install the machine in areas where it could
come into contact with jets of water.
The machine can be used with the following:
- Coffee grains
- Decaffeinated coffee powder
- Milk (not powdered)
The use of any other substance not listed here
above may cause serious damage to the machi-
ne itself.
WARNING
WARNING
WARNING
The machine is designed to operate at tempera-
tures ranging from +5°C to +40°C (41°F - 104°F).
WARNING
4 Particularly the first time, wash the tank with soapy
water and then carefully rinse off all soap.
5 Fill the water tank with water.
6 Make sure that the outside of the water tank is dry.
7 Return the water tank to its site.
4.1 MACHINE
INSTALLATION
(VERSION WITH TANK)
Switch off the machine before filling or removing
the water tank.
Once the machine has been withdrawn from the
packaging, carry out the following instructions:
1 Position the unit on a horizontal surface.
2 Open the hatch.
3 Withdraw the water tank by pulling it upwards.
WARNING
8 Close the hatch.
To Next Page
Loading...
