Nuova Simonelli PRONTOBAR - Pouring Group Maintenance and Removal

61
EN
DISPLAY CAUSA EFFECT SOLUTION NOTE
FRONT PANEL
POSITION
MACHINERY OFF
FRONT PANEL OPEN
Front panel open. The machine fun-
ctions are blocked.
Close the front
panel.
WASHING CYCLE
IS NEEDED
The set number of
cycles programmed
before washing,
has been excee-
ded.
The message will
appear on the
display but the
machine will con-
tinue to deliver
drinks.
Do a washing
cycle (see para-
graph WASHING
THE DELIVERY
UNIT AND MILK
FOAMER)
WASHING THE
MILK
CIRCUIT IS
NEEDED
The set number of
hours programmed
from time of last
milk based drink
before washing,
has been excee-
ded.
The message will
appear on the
display but the
machine will con-
tinue to deliver
drinks.
Perform a washing
cycle for the milk
foamer only. As
in the case of a
complete washing
cycle, you must
keep the key pres-
sed down
for
5 seconds without,
however, inserting
cleanser tablets
for this group’s
washing.
(See only points
1,2,3,4 of the para-
graph ‘WASHING
THE DELIVERY
UNIT AND MILK
FOAMER’)
SHUT DOWN
CLEAN
An end of service
wash was set for
the delivery unit
during the program-
ming stage.
An end of servi-
ce wash must be
performed befo-
re the machine is
switched off.
Press the ENTER
key as shown on
the display. The
machine will auto-
matically perform
an end of service
wash, dispensing
approx. 50cm
3
(3.0512 cu in) of
water and will then
switch off.
CLEAN WARNING
MILKCLEANWARNING
SHUTDOWN CLEAN
PRESS ENTER