Nuova Simonelli TALENTO - Page 53

51
EN
2.10 CLEARING (Total wash cycles)
Press ENTER to enter the sub menu: all of
the beverage keys (1-8) will start to flash and the
display will read:
Press and hold down ENTER
for 10 seconds
to read the absolute total (not resettable to zero):
Press and hold down ENTER
for 6 seconds
from the total absolute menu to reset the CLEARING
counter.
Press RESET
to quit the submenu.
Press RESET
to quit the submenu.
3. PROG DOSES (Dose programming)
Pressing ENTER it is possible to access the
sub menu and then to use the
keys
to select the key to be programmed. The numbers,
from 1 to 10 are shown in fig.1
Fig. 21
1
2
3
4
6
7
8
9
5
10
Press ENTER again to enter the function
programming mode for each single key. Use the
to select the required beverage:
DISABLE: key disabled
COFFEE: coffee cycle
MILK COFFEE: milk cycle + coffee cycle
COFFEE MILK: coffee cycle + milk
CAFFELATTE: milk cycle + coffee together
MACCHIATO: milk cycle + pause (3 seconds) + coffee
MILK: milk cycle
TEA: pours hot water
MANUAL STEAM: timed steam delivery
AUTOSTEAM: steam delivery with temperature
probe
Press ENTER
to confirm the required bever-
age.
List of functions that can be programmed for the
COFFEE beverage:
• GRIND TIME (used to set the grinding time)
• GRIND SEL (used to set the default grinder)
• VOLUME CC (used to set the volume of water
in the coffee)
• PRE-BREWING (used to set the pre-brewing time)
• TAMPING (used to enable/disable pressing)
• ADD WATER (used to set the amount of addi-
tional hot water)
List of the functions that can be programmed for the
MILK COFFEE beverage:
• MILK TIME (used to set the milk time/amount)
• NO AIR TIME (used to set the milk time/amount
without foam)
• AUTOWASHING (used to set the washing time
at the end of pouring)
• GRIND TIME (used to set the grinding time)
• GRIND SEL (used to set the default grinder)
• VOLUME CC (used to set the volume of water
in the coffee)
CLEANING
N. 000000056
CLEANING
ABSOLUTE TOT
N. 00000056