Fig. 35
62
EN
NOTE:
Follow the instructions applied on the label on
the inside of the front door too.
9.8 CLEANING THE MILK
FOAMER
IMPORTANT: Proceed with caution
NOTE: For intervals of more than three hours
between one cappuccino and the next, it is
advisable to wash the cappuccino maker by
taking in water through the milk suction pipe
instead of milk.
• To reassemble proceed inversely, attaching the
milk foamer tubes properly.
NOTA: To make the reassembling procedure easier,
an explanatory label has been attached to
the front door.
• Remove the lid of the pouring nozzle by pulling
it towards you.
• Remove the cappuccino maker from the nozzle
by sliding it upwards.
• Disconnect all of the connected pipes.
• Remove the cappuccino maker and wash it
with care.
To Next Page
Loading...
