Nustep T4R - Cover Removal;Installation

19
Cover Removal / Installation
1.
2.
3.
Remove seat rail
cap.
Remove seat rail
cap bolt.
Roll seat off of
seat rail.
Keep upward
pressure on front
of seat to prevent
scratching end of
seat rail.
• Phillips screw-
driver
• 3/16” hex wrench
• Scratch awl (use
to align holes
before screws)
Tools Required:
4.
Remove 6
screws from top
cover.
Note: In center
of top cover,
only 2 screws
are used in the
forward 2 holes.
The T4r seat
assembly is heavy;
it weighs 50 lbs (23
kg). To avoid injury,
or damage to the
product, use caution
when removing or
installing. Obtain
assistance as
required. Use proper
lifting technique.
CAUTION
!