To Next Page

To Previous Page

INSTALLATION, USE & CARE INSTRUCTIONS

INSTALLATION

INSTALL THE UNIT

1. Run house power cable between service panel and unit

location. Stub out a 2-foot length of power cable inside

the cabinet. Insert the power cable in the unit through the

7/8” diameter strain relief previously installed.

NOTE: Not necessary if the optional HCK44 cord

connection kit is used.

2. Insert the unit in the cabinet, until you feel a ‘click’ from

both sides of the unit, confirming that the Ease of Install

hooks rest on the top of the cabinet bottom sides , or

cabinet brackets  or  (FIG. 23). Move the unit from

left to right, from rear to front and up to ensure the Ease

of Install hooks are retaining the unit inside the cabinet.

NOTE: The unit will be protruding below the cabinetry until

tightened.







FIG. 23

FIG. 24

NOTE: If, for any reason, the unit has to be removed

from the cabinet, it is possible to disengage the

Ease of Install hooks. To do so, while holding and

pushing on one side of the unit, lift simultaneously

Ease of Install hooks levers (1 and 2, grey parts

in FIG. 24) in the other side of the unit until the

hooks are retracted.

NuTone BBN3306SS User Manual

Questions and Answers: