What to do if my NutriMill Harvest Kitchen Appliances hopper will not attach?
If the hopper will not attach to your NutriMill Kitchen Appliance, make sure the tabs on the top grindstone are seated into place. Also, loosen the adjustment knob to the coarsest setting.
What to do if my NutriMill Harvest motor stalls during operation?
If the motor stalls, it might be due to overheating or improper use. To resolve this, unplug the mill and let it cool down for at least 30 minutes. Remove the hopper, empty any remaining grains or legumes, and remove the upper millstone. Ensure the stones and milling chamber are clean and dry. Try restarting the motor with the upper stone and hopper off. If it starts, turn off the mill, reassemble it, and begin milling again.
How to fix unusual smell or noise from NutriMill Harvest?
An unusual smell or noise during operation indicates that the milling heads are rubbing too tightly. To fix this, rotate the adjustment knob to a coarser setting.
How to start NutriMill Harvest if motor will not start?
If the motor won't start, rotate the adjusting knob to a coarser setting (counterclockwise) until the motor starts. Then, adjust the texture knob to your desired setting.
Why does my NutriMill Kitchen Appliances make unusual smell or noise?
If your NutriMill Kitchen Appliance is making an unusual smell or noise, it may be caused by the milling heads rubbing during operation. Rotate the adjustment knob counter-clockwise to resolve this.
General| Power | 450 watts |
|---|---|
| Category | Grain Mill |
| Manufacturer | NutriMill |
| Hopper Capacity | 4.5 cups |
| Material | Stainless Steel |
| Grinding Technology | Stone & Impact Milling |
| Warranty | 5 years |
| Flour Container Capacity | Not specified (uses any container) |
To Next Page
