NuWave Nutri-Pot 33501 - Operating Instructions; Step-by-Step Guide

10
Operating Instructions
Silicone Gasket Installation
OPERATING INSTRUCTIONS
Open lid: Hold the lid handle. Turn the lid counter clockwise to open position
then raise it. Make sure to install the Water Collector Box.(See below)
1
2
Place ingredients and water in the inner pot. Ingredients and water
should not exceed 4/5 height of the inner pot. If the ingredients expand
easily in water, then the total amount should not exceed 3/5 height
of the inner pot. The minimum amount of ingredients and water is
normally 1/5 height of the inner pot. (See below).
3
Place the inner pot in the Housing. Clean the bottom of inner pot and
surface of heating plate before inserting the inner pot. (See below).
4
Close lid:
• Check that the Silicone Gasket is secured in the lid before closing.
• Hold the lid handle. Lower the lid, then turn the lid clockwise to close.
A sound will conrm that the lid has been closed properly. (See below).
4
5
3
5
1
5
The push rod on the side
of the lid needs to align
properly to the base in order
for the lid to lock into place.
Right side
Note: Install the
Water Collector
Box on the right
side just below
the handle.
At a 45˚ angle
press in.