NuWave OXYPURE ZERO PLUS - Page 13

nuwavenow.com | 13
RESETTING FILTERS 2 & 3
1. Press and hold TIMER for 2 seconds,
until 2 beeps are heard.
2. The CLEAN FILTER 2/3 light turns off and
the 1st bar on the Air indicator will be lit.
CLEAN THE OZONE EMISSION
REMOVAL FILTER:
Cleaning depends on usage.
1. Remove the Filter from slot .
2. Use a vacuum with a brush
attachment and vacuum up
and down then side to side.
3. Flip and repeat to vacuum the
other side of the Filter.
4. Repeat this process on the
other side.
CLEANING THE DUST SENSOR
The Dust Sensor requires regular cleaning
(approximately every 3 months) for the unit
to operate efciently.
1. Open the Dust Sensor Cover.
2. Using a dry cotton swab remove any
dirt or dust from the Dust Sensor. Can
use a slightly wet cotton swab for heavy
buildup.
3. Remove any moisture with a dry cotton
swab.
• If your OxyPure is set up in an area with
high dust accumulation, more frequent
cleaning of the Dust Sensor is needed.
WARNING
DO NOT Immerse, wash or wipe with
water, this will result in permanent damage
to the Ozone Filter. It must be replaced!
CLEAN STAINLESS STEEL PRE-FILTER:
Clean every 2 months depending on use.
1. Use a vacuum with a
brush attachment.
2. Clean the Filter with warm
soapy water.
3. Rinse the Filter thoroughly
and remove any soap particles.
4. Allow the Filter to dry completely BEFORE
placing it into slot using the tabs.
1. Remove the Filter (2/3) using
the handles.
2. Spray the Filter with a mild
degreaser or dish soap and let
it sit for 2-3 minutes.
3. Submerge the Filter in warm
water, shake, and remove.
4. Repeat this process until the Filter water
is clean.
5. Dry the Filter completely before inserting
in their proper slots, 2 or r .
• Note: The Bio-Guard™ Filter may
discolor and retain odor after prolonged
exposure to thick smoke and strong
odors. This prolonged exposure will
require more frequent cleanings to ensure
maximum ltration efciency.
Ozone Emission
Removal Filter
CLEANING & MAINTENANCE
2 3
4
1
Bio-Guard
™
Filter 2
Pre Filter
Clean Filter 2 & 3 Schedule
3 Months Yellow Routine cleaning.
6 Months Orange Should be cleaned for
continued efficiency.
12
Months
Red Clean for optimal
performance
especially if the first 2
were missed.
CLEAN FILTER 2 & 3
The Bio-Guard™ Filters should or must
be cleaned according to the Cleaning Chart.
CLEANING THE UNIT