nvent 910 Series - User Manual

77 pages

Save Page as PDF

To Next Page

910 Series Heat Trace Controller

Installation, Operating and Maintenance Instructions

Firmware versions up to V3.1x

Main Page

Table of Contents2
Certification4
Conducted and Radiated Emissions-FCC/DOC Statement of Compliance4
Exclusive Remedies4
Limited Warranty4
Warranty Exclusion/Disclaimer4
Section 1-Overview5
- Introduction5
- Controllers Covered by this Manual5
- Product Overview5
- Modular Components6
- Controller Assemblies7
- Ordering and Configuration Guide7
Section 2-Installation and Wiring9
- Introduction9
- Initial Inspection9
- Operator Safety Considerations9
- Operating Environment9
- Installation Location9
- Mounting Procedures9
- Wiring10
- Initial Power-Up13
- Setup for the 91013
Section 3-Operator Console and Operation14
- Alphanumeric Display14
- Keypad14
- LED Indicators15
- Operational Basics15
Section 4-Operator Console Modes18
- Alarm Mode18
- Monitor Mode19
- Configure Mode20
Section 5-Configuration Parameter Details26
- Introduction26
- Point Setup Parameters26
- Miscellaneous Setup Parameters33
- Temperature Sensor Alarms Configuration34
- Other Alarms Configuration37
- Communications Setup44
- Operator Console Functions46
Section 6-Monitored Parameter Details48
- Introduction48
- Analog Readings48
- Maintenance Data49
Section 7-Control Modes51
- Introduction51
- Switch Control Modes51
- Load Shedding Control Mode53
Section 8-Troubleshooting54
- Operator Checks54
- Common Problem Areas54
- Common Alarms-What to Look for56
- Section 9-Maintenance60
- Operator Maintenance60
- Replaceable Parts60
Appendix A-Specifications61
Appendix B-Typical Enclosure Dimensions62
- Standard Fiberglass EMR Assembly #10170-00162
- Optional Stainless Steel EMR Assembly #10170-00363
- Standard Fiberglass SSR Assembly #10170-000264
- Optional Stainless Steel SSR Assembly #10170-00465
- 910 Series HTC Control Module Dimensions66
Appendix C-Wiring Diagrams67
- TS Wiring67
- Power Wiring67
- Alarm Output Wiring68
- External Input/Output Port Wiring70
Appendix D-Htc Load Shedding Sequence71
Appendix E-100 Ω Platinum RTD Table72
- DIN 43760-100 Ω Platinum Resistance Temperature (RTD)-0.00385 Ohms/Ohm/°C72
Appendix F-100 Ω Nickel-Iron RTD Table73
Appendix G-Factory Default Configuration V3.1X74
- 910 Series HTC74

Need help?

Do you have a question about the nvent 910 Series and is the answer not in the manual?

nvent 910 Series Specifications

General

Brand	nvent
Model	910 Series
Category	Controller
Language	English

Related product manuals

nvent RAYCHEM Elexant 4010i

101 pages

nvent RAYCHEM Raystat V5

19 pages

nvent RAYCHEM T2000

81 pages

nvent 910 Series - User Manual

Table of Contents

nvent 910 Series Specifications

Related product manuals