Jetson AGX Xavier Developer Kit
Jetson AGX Xavier Developer Kit DA_07976_001_01 | 9
WORKING WITH L4T
NVIDIA L4T provides the Linux kernel, bootloader, board support package (BSP), and
sample filesystem for the Jetson AGX Xavier Developer Kit. JetPack installer installs the
L4T sample file system to your developer kit to get you up and running quickly.
L4T is also available for download directly from the main L4T page
on the Jetson
Developer Site.
A command line flashing utility is included in the L4T driver package, and the L4T
documentation describes how to flash your developer kit.
The L4T documentation also includes documents such as the Platform Adaptation and
Bring-Up Guide, which describes how to port the L4T BSP and bootloader from your
developer kit to a new hardware platform incorporating the Jetson module. Porting L4T
to a new device enables use of the other JetPack components on that device, along with
the software you’ve created using the developer kit.
COMPLIANCE INFORMATION
The NVIDIA Jetson AGX Xavier Developer Kit is compliant with the regulations listed
in this section.
UNITED STATES
Federal Communications Commission (FCC)
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference, and (2) this device
must accept any interference received, including any interference that may cause
undesired operation of the device.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
To Next Page
Loading...
Need help?
General
