•
•
•
•
Allow the NIC to accept DCBX configuration from the remote
peer
Enable DCBX
Enable the internal LLDP client
Select which LLDP TLV will be generated by the NIC
General Added support for all tools to work when the MST driver is not installed Linux
mstcables Added support for dumping Mellanox cables EEPROM by mstdump/
mstdump tools
Linux Windows
FreeBSD
Added a new tool (mstcables) that reads/writes Mellanox cable registers
and queries the cables info
Linux Windows
FreeBSD
Build Created one mstflint package for all 64 bits FreeBSD OSs FreeBSD
mstfwmanager_pci Removed support for mstfwmanager_pci tool (it is deprecated), since all
the Linux tools can work without a kernel now. When required, use
mstfwmanager instead.
Linux
mcra Added support for clearing VSEC PCI semaphore by the mcra tool. The
new capability can be used after killing a tool forcefully without
clearing the semaphores.
Supported devices: ConnectX-4, ConnectX-4 Lx and Connect-IB
All
mstreg Added support for Switch-IB, Switch-IB 2, and Spectrum in the mstreg
tool
All
mstconfig Added the mstconfig tool to the mstflint package for WinPE Windows
mstconfig Added a backup command in mstconfig which allows user to save backup
of the non-volatile configurations in a RAW file. This file can be set on
the device by using the set_raw command
All
Build Added support for running wrapped python tools (like fwtrace) in
PPC64, PPC64LE and Arm platforms
Linux
mstreg Added support for PPRT and PPTT registers in ConnectX-4 and
ConnectX-4 Lx
All
Rev. 4.3.0
General Added support for Spectrum device. All
Added support for Switch-IB 2 device. All
Added support for ConnectX-4 and ConnectX-4 Lx in VMware Esxi. VMware ESXi
Added support for VMware ESXi 5.5 Native. VMware ESXi
4th generation and 5th generation IC devices are now also named Group
I ICs and Group II ICs, respectively.
N/A
To Next Page
Loading...
Need help?
General