To Next Page

To Previous Page

114

mstburn Added the -fw_dir option which looks for a suitable firmware file in the

given directory

Linux

Support for generating a non-fail-safe image for ConnectX/ConnectX-2,

InfiniScale IV, and BridgeX devices

Linux

Debug tools Updated the msti2c utility Linux

Added the mget_temp utility which reads the temperature of the

ConnectX/ConnectX-2, InfiniScale IV, and BridgeX devices

Linux

mstflint Bug Fixes History

The table below lists the history of bugs fixed.

Internal Ref.

No.

Issue

2578580 Description:Fixed an issue that resulted in getting MVPD read errors from the

mstfwmanager during fast reboot.

Keywords:mstfwmanager, MVPD_READ4 failed, fast reboot

Discovered in Version: 4.16.0

Fixed in Release: 4.17.0

2628490 Description:Fixed inconsistent flashing of the firmware when using the IPMB service.

Keywords:mstflint

Discovered in Version: 4.16.0

Fixed in Release: 4.17.0

2395589 Description:Changed the mstflint "--activate" flag behavior to include a minimal delay

of 1 second to avoid disconnections if the connected port is being activated.

To use the "legacy" activation flow, use the "--activate_delay_sec 0" command.

Keywords:"--activate" flag, mstflint

Discovered in Version: 4.16.0

Fixed in Release: 4.17.0

2494596 Description:mstflint now supports the "--activate_delay_sec" flag which performs the

activation on the newly burned firmware after the specified delay.

Note: The burn flow will be locked after this command has been sent for a couple of

minutes, until activation flow is done.

Keywords:"--activate_delay_sec" flag, mstflint

Discovered in Version: 4.16.0

Nvidia MSTFLINT Documentation

Other manuals for Nvidia MSTFLINT