mstflint Added support for flash type SST25VF016B Linux
Added support for flash type M25PX16 Linux
Added an option to set the VSD and GUIDs in a binary image file. This is
useful for production to prepare images for pre-assembly flash burning.
These new commands are supported by Mellanox 4th generation devices
Linux
Added an option to set the VSD and GUIDs on an already burnt device.
These commands (“sg” and “sv”) re-burn the existing image with the
given GUIDs or VSD. When the 'sg' command is applied on a device with
blank (0xff) GUIDs, it updates the GUIDs without re-burning the image
Linux
mst Added support for using ibutils2/ibdiagnet and ibnetdiscover in the 'mst
ib add' command
Linux
Removed the _uar, _msix and _ddr devices from the mst device list Linux
Debug tools Added support for routing I2C bus to the IS4 device on IS50XX systems Linux
Rev. 2.6.1
Bug Fixes See .MFT Bug Fixes History v4.18.1 Linux
Rev. 2.6.0
mstflint
installation
change
Added the options: --without-image-generation, --disable-dc, and --
without-kernel which allow for a partial installation in order to avoid
problems with SW dependencies
Linux
Now allows a non-root user to prepare mstflint RPMs Linux
All Added Mellanox ConnectX-2 and BridgeX support Linux/Windows
mstflint Added a CRC check for the full image Linux
Support for query/burn of clp-gpxe ROM Linux
Prevents burning a ConnectX-2 image onto a ConnectX device and vice
versa
Linux
Added a logging option to mstflint Linux
For the ConnectX device family only:
Added commands for an independent burn/read/remove of an
Expansion ROM image.
For firmware versions earlier than 2.7.000: It is possible to read the
ROM image, or to replace an already existing ROM image (by the burn
command). However, burning a new ROM image in case a previous image
did not exist is not possible, nor is it possible to remove an existing ROM
image
Linux
To Next Page
Loading...
Need help?
General