•
•
•
•
•
•
•
•
•
mstconfig – Changing Device Configuration Tool
The mstconfig tool allows the user to change some of the device configurations without
reburningthe firmware. The configuration is also kept after reset.
By default, mstconfigshows the configurations that will be loaded in the next boot.
For 5th generation devices, it is also possible to query the default configurations and
theconfigurations that are used by the current running firmware.
Tool Requirements
OFED/UPStreamdriver to be installed and enabled (for ConnectX-3 and ConnectX-3 Pro)
Access to the device through BDF format
For the adapter cards below, the following firmware versions are required:
ConnectX
®
-3/ConnectX-3 Pro: v2.31.5000 or above
Connect-IB
®
: v10.10.6000 or above
Supported devices:
Adapter cards: ConnectX-3/ConnectX-3 Pro/Connect-IB/ConnectX-4/ConnectX-4 Lx/
ConnectX-5/ConnectX-5 Ex/BlueField
®
/ConnectX-6/ConnectX-6 Dx
Switches: Switch-IB/Switch-IB 2/Spectrum™/Spectrum-2/Quantum
Changing device configurations enabled.
mstconfig Synopsis
# mstconfig [Options] <commands> [Parameters]
where:
-d|--dev <device> Perform operation for a specified MST device.
-b|--db <filename> Use a specific database file.
-f|--file <conf_file> Raw configuration file.
-h|--help Display help message.
-v|--version Display version info.
-e|--enable_verbosity Show default and current configurations.
-y|--yes Answer yes in prompt.
-a|--all_attrs Show all attributes in the XML template
-p|--private_key pem file for private key
For changes after a successful configuration to take effect, reboot the system.