-u|--key_uuid Keypair uuid
clear_semaphore Clear the tool semaphore.
i[show_confs] Display information about all configurations.
q[uery] Query supported configurations.
r[eset] Reset all configurations to their default value.
s[et] Set configurations to a specific device.
set_raw Set raw configuration file.(only Connect-IB/ConnectX-4/Lx)
get_raw Gets raw configuration file (5th generation/Group II devices only)
backup Backup configurations to a file (only Connect-IB/ConnectX-4/Lx).
Use set_raw command to restore file.
gen_tlvs_file Generate List of all TLVs. TLVs output file name must be specified.
(*)
g[en_xml_template] Generate XML template. TLVs input file name and XML output file
name must be specified. (*)
xml2raw Generate binary configuration dump file from XML file. XML input
file name and bin output file name must be specified. (*)
raw2xml Generate configuration file from XML file. XML input file name and
bin output file name must be specified. (*)
xml2bin Apply a configuration file, that was created with create_conf
command. bin input file name must be specified. (*)
create_conf Generate Configuration file from XML file. XML input file name
and bin output file name must be specified. (*)
apply Apply a Configuration file. bin input file name must be specified.
(*)
Examples of mstconfig Usage
Querying the Device Configuration
To query the device’s configuration, use the following command line:
# mstconfig -d <device> query
ConnectX-3 Example:
To Next Page
Loading...