•
•
•
•
•
Added Secure host feature which enables ConnectX family devices to
block access to its internal hardware registers. The hardware access in
this mode is allowed only if a correct 64 bits key is provided (see
mstflint changes).
mstflint tools cannot run on a device with hardware access disabled.
This feature is enabled only with supporting firmware
Linux
Removed support for Itanium (ia64) Linux
mstflint Added the following commands:
enable/disable access to the hardware
set/change the key used to enable access to the hardware
Linux
The ROM section in the image now contains multiple boot images.
Therefore the mstflint was modified to display information for all of the
images in the ROM section
Linux
Added support to display/burn UEFI ROM Linux
Added support for burning firmware via Command Line interface on
SwitchX devices
Linux
mstburn Added option to add or replace a single keyword in the VPD writable
section (-vpd_set_keyword flag)
Linux
Added the option to set a binary VPD field data Linux
mstflint
installation
Added the option --without-kernel which allows user to install mstflint
without the mst kernel
Linux
Rev. 2.6.2
mstflint
installation
change
RPM based installation:
Applications are installed using a pre-compiled binary RPM
Kernel modules are distributed as a source RPM and compiled by
the installation script
Fast installation process
Linux
Removed prerequisite libraries: expat and zlib-devel Linux
The package tools, libraries and headers are now installed under:
{ prefix }/bin or { prefix }/lib and { prefix }/include dirs. Directory /
usr/mst is not created. For example, the “mread”, “mwrite” and
“mcra” tools that were previously installed by default under /usr/mst/
bin, now are installed under /usr/bin
Linux
Linux
Removed the InfiniScale and InfiniBridge tools Linux
Removed the Infinivision tool set Linux
Removed the isw tool. The isw tool functionality was replaced by the
"msti2c" tool. For example, to scan the devices on the i2c bus, run:
> msti2c -d <dev> scan instead of > isw -d <dev>
Linux
To Next Page
Loading...
Need help?
General