•
•
General Added mstconfig tool. This tool sets firmware configurations for
Mellanox adapters. These configurations are nonvolatile they apply over
device reboots. For further details, please run “mstconfig -h”. The tool
is at beta level
Linux
Added support for ConnectX-3 silicon device Windows
Added the I2CBridge (Dimax’s Driver for USB to I2C Adapter) as part of
the Winmstflint installation package. However, the I2CBridge is not
installed by default
Windows
mstflint
installation
change
Removed the isw tool. The isw tool functionality was replaced by the
"msti2c" tool. For example, to scan the devices on the i2c bus, run:
> msti2c -d <dev> scan instead of > isw -d <dev>
Windows
mget_temp mget_temp displays a more accurate temperature for ConnectX-2
devices by using chip specific thermal calibration data
Linux
mstflint Added support for Atmel AT25DFxx flash family Linux
Cleared error messages displayed when trying to burn firmware image of
a different device. For example when burning ConnectX-2 firmware
image on ConnectX-3 device
Linux
Added support for flash type SST25VF016B Windows
Added support for flash type M25PX16 Windows
The ROM section in the image now contains multiple boot
images. Therefore mstflint was modified to display information
for all of the images in the ROM section.
Added support to display/burn UEFI ROM/
Windows
Added an option to set the VSD and GUIDs in a binary image file. This is
useful for production to prepare images for pre-assembly flash burning.
These new commands are supported by Mellanox 4th generation devices
Windows
Added an option to set the VSD and GUIDs on an already burnt device.
These commands (“sg” and “sv”) re-burn the existing image with the
given GUIDs or VSD. When the 'sg' command is applied on a device with
blank (0xff) GUIDs, it updates the GUIDs without re-burning the image
Windows
mst Added support for using ibnetdiscover in the 'mst ib add' command Windows
mstburn Added support for VPD read/write Windows
Rev. 2.7.0a
Bug Fixes See .MFT Bug Fixes History v4.18.1 Linux
Rev. 2.7.0
General Added support for Mellanox ConnectX-3 and SwitchX silicon devices Linux
To Next Page
Loading...
Need help?
General