•
•
•
•
•
mstdump Added support for the mstdump utility (at beta level) Linux/Windows
mstmcg Renamed mcg to mstmcg Linux/Windows
spark spark was removed from mstflint version 3.0.0 Linux/Windows
Supported Devices The following adapter cards and switch systems are no longer supported
in mstflint version 3.0.0:
InfiniHost 4X
InfiniHost III Ex
InfiniHost III Lx 4X
InfiniScale
InfiniScale III
Linux/Windows
Rev. 2.7.2b
All Added support for WinPE 4.0 OS Windows
Rev. 2.7.2
General It is no longer required to run mst start/stop when using Winmstflint
tools. The service is automatically loaded/unloaded when an mstflint
tool is running. The mst service installation was removed from the setup
Windows
Added support for SwitchX silicon devices Windows
mstflint Added support for Atmel AT25DFxx flash family Windows
Added support for burning firmware via Command Line Interface (CLI)
on SwitchX devices
Windows
mget_temp mget_temp displays a more accurate temperature reading for
ConnectX-2 and ConnectX-3 devices by using the adapter’s specific
thermal calibration data
Windows
Rev. 2.7.1a
Added the mcg
tool (Beta level)
The mcg tool displays the current multicast groups and flow steering
rules configured in the device.
Target users: Developers of Flow Steering aware applications. This tool
dumps the internal steering table which is used by the device to steer
Ethernet packets and Multicast IB packets to the correct destination
QPs.
Each line in the table shows a single filter and a list of destination QPs.
Packets that match the filter are steered to the list of destination QPs
Linux
Removed support
for In-band access
on OFED 1.4
InfiniBand driver
In-band access is supported using OFED 1.5.X and higher Linux
Rev. 2.7.1
To Next Page
Loading...
Need help?
General