To Next Page

To Previous Page

117

•

Internal Ref.

No.

Issue

2084837 Description: Setting the speeds (50GbE and 100GbE) for the new devices (Connect-X 6 and

above, Quantum switches and above) requires specifying the number of lanes for the

speed:

mstlink -d <dev> --speeds [50G_2X | 50G_1X | 100G_2X | 100G_4X]

For PRBS mode, to work with PAM4 speeds, use the same speed naming for (50GbE, and

100GbE).

Keywords: mstlink

Discovered in Version: 4.14.0-1

Fixed in Release: 4.16.0

2183083 Description:MFT tools do not support using combined short flags without a separation

between them.

For example:

Not recommended:-emc

Recommended:-e -m -c

Keywords: Short flags

Discovered in Version: 4.15.0

Fixed in Release: 4.16.0

2297524 Description:Fixed an issue that caused lifecycle to be wrongly reported in ConnectX-6

adapter cards.

Keywords: Lifecycle, ConnectX-6

Discovered in Version: 4.14.0-105

Fixed in Release: 4.16.0

2319179 Description:Fixed an issue that caused HMAC not to be written in livefish.

Note: HMAC is now supported only from the Arm side and only if not in secure mode.

Keywords: mstlink

Discovered in Version: 4.14.0-105

Fixed in Release: 4.16.0

Nvidia MSTFLINT Documentation

Other manuals for Nvidia MSTFLINT