Device #1:
----------
Device type: ConnectX4
PCI device: 41:00.0
Configurations: Next Boot New
SRIOV_EN 0 1
NUM_OF_VFS 0 8
Apply new Configuration? ? (y/n) [n] : y Applying... Done!
-I- Please reboot machine to load new configurations.
Using mstconfig to Set Preboot Settings
For a full description of the preboot configurable parameters refer to Supported Configurations and
their Parametersunder "Preboot Settings".
Example: Enable boot option ROM on port 1, set boot retries to 3 and set the boot protocol toPXE.
# mstconfig -d 41:00.0 set BOOT_OPTION_ROM_EN_P1=1 BOOT_RETRY_CNT_P1=3 LEGACY_BOOT_PROTOCOL_P1=1
Device #1:
----------
Device type: ConnectX3Pro
PCI device: 41:00.0
Configurations: Next Boot New
BOOT_OPTION_ROM_EN_P1 False(0) True(1)
BOOT_RETRY_CNT_P1 0 3
LEGACY_BOOT_PROTOCOL_P1 2 1
Apply new Configuration? ? (y/n) [n] : y
Applying... Done!
-I- Please reboot machine to load new configurations.
Example: Configure VLAN ID to 3 on port 2
# mstconfig -d 41:00.0 set BOOT_VLAN_P2=3
Device #1:
----------
Device type: ConnectX3Pro
PCI device: 41:00.0
Configurations: Next Boot New
BOOT_VLAN_P2 1 3
Apply new Configuration? ? (y/n) [n] : y
Applying... Done!
-I- Please reboot machine to load new configurations.
mstconfig Raw Configuration Files
mstconfig allows applying raw configuration file for a pre-set configuration. Raw configurationfiles
are intended for advanced users. This document does not cover the generation of such files.
Set the raw configuration file:
# mstconfig -f ./tlv_file.conf -d 41:00.0 set_raw
Raw TLV #1 Info:
Length: 0xc
Version: 0
OverrideEn: 1
Type: 0x00000080
Data: 0xa0000000 0xa0020010 0x00000000
Raw TLV #2 Info:
Length: 0x4
Version: 0
OverrideEn: 1
Type: 0x01020012
Data: 0x0000000b
Raw TLV #3 Info:
Length: 0x8
Version: 0
OverrideEn: 1
Type: 0x00000190
Data: 0x00000010 0x00007d00
Raw TLV #4 Info:
Length: 0x4
Version: 0
OverrideEn: 1
Type: 0x00000082
To Next Page
Loading...
Need help?
General