EasyManuals Logo

Nvidia MSTFLINT Documentation

Nvidia MSTFLINT
123 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #55 background imageLoading...
Page #55 background image
55
3.
1.
2.
3.
1.
a.
2.
3.
1.
# mstflint -d 41:00.0 -i fw-4099.secure.bin b
For changes to take effect, reboot is required.
Setting the Secure Host Key
To set the key, run:
# mstflint -d 41:00.0 set_key 22062011
Setting the HW Key - OK
Restoring signature - OK
Disabling/Enabling Access to the Hardware
Access the hardware while hardware access is disabled:
# mstflint -d 41:00.0 q
E- Cannot open 41:00.0: HW access is disabled on the device.
E- Run "mstflint -d 41:00.0 hw_access enable" in order to enable HW access.
Enable hardware access:
# mstflint -d 41:00.0 hw_access enable
Enter Key: ********
Disable hardware access:
# mstflint -d 41:00.0 hw_access disable
Removing the Secure Host
To remove the secure host feature:
Make sure you have INI and MLX file suitable for the device.
Remove cr_protection_en=true from the INI (if present)
Burn the firmware on the device (make sure hardware access is enabled prior to burning):
# mstflint -d 41:00.0 -i fw-4099.unsecure.bin b
Execute a driver restart in order to load the unsecure firmware:
# service openibd restart
Key Loss Recovery
If a key is lost, there is no way to recover it using the tool. The only way to recover is to:
Connect the flash-not-present jumper on the card.
A driver restart is required to activate the new key.
This section is applicable to Group 1 network adapters only.

Table of Contents

Other manuals for Nvidia MSTFLINT

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Nvidia MSTFLINT and is the answer not in the manual?

Nvidia MSTFLINT Specifications

General IconGeneral
BrandNvidia
ModelMSTFLINT
CategoryTools
LanguageEnglish